|
Jet 1100 Dust Collector
|
I have my dust collector tucked back into the far corner of the shop. As you can
see, a bunch of left over materials were stacked around it when this photo was taken.
It is an 1100 CFM rated unit, with a 1.5 HP motor. It is wired 220 volt and
plumbed to all of my stationary tools. Each tool is fitted with a blast gate and in
most cases only one gate will be open at any one time. If I am working on the
tablesaw and the jointer at once for example, I may have two blast gates open. Even
then this unit does a better than decent job. The system is plumbed through an
upstream cyclone which you can
view here. |
|
The dust collector is controlled via Long Ranger remote control. |
|
|
|
|
|